How do I reset my M365 scooter?

How do I reset my electric scooter?

If the scooter is over loaded, the circuit breaker may trip and shut off power to the motor. Correct the riding condition that caused the over load, wait a few seconds, and then push the reset button to reset the circuit.

Why is my m365 beeping?

Answer: The E-Scooter without being activated will keep beeping when turned on and its speed is limited to 10 km/h. You need to install Mi Home app and follow the on-screen instructions in the app to activate your scooter for the first use. The beeping sound will not stop until the scooter is activated.

Why is my electric scooter not starting?

When your electric scooter doesn’t respond, check if the main ignition fuses are turned on. If it’s not, switch it on, and start the engine again. If it doesn’t start, you need to replace it with a new fuse. It’s best to have a technician remove and replace your broken fuse for your safety.

Why is my scooter beeping and not moving?

Beep Codes. Condition: The battery voltage is to low and can not power up the scooter. Solution: Replace charge the scooter completely, or replace the batteries. Condition: The battery voltage is to high and the scooter can not operate.

IT IS INTERESTING:  Why scooters are costlier than bikes?

What is the official app for Xiaomi M365?

Using the Xiaomi Smart Phone App with Your Xiaomi M365 Electric Scooter. The Xiaomi M365 Electric Scooter and the M365 Pro Versions both come with the option of connecting it with an app on your smartphone to give you access to a number of cool options and features that aren’t available with many other scooters.

Why does my bird scooter keep beeping?

If it detects a rider is on the sidewalk, it’ll make a beeping sound to tell the rider to go back into a bike lane or roadway. (It doesn’t turn off or slow down the scooter like some other tech.) Once a rider returns to the street or bike lane, the scooter beeps again, albeit more positively.

How do I disconnect my electric scooter?

With the scooter powered down, unscrew the three small cross-head screws securing the control board and carefully lift it up and out. Release the cable-tie and pop off the rubber thimble to expose the three control connectors and carefully unplug these.